![]() Thats assuming of course EVERYTHING else is in good condition and as per original settings. if its dry either no fuel or not enough is getting through. If so it may be too much fuel flooding the engine. ![]() Is the plug wet when it's failed to start. Having said that it sounds like it's not far off. Try and getting running with the original carb again then try messing with the new carb. (you know this was working so your eliminating an unknown quantity, the new carb.) If not make sure it's fully dried out and try refitting it. It's easy to disturb plugs etc when messing around the engine.ĭid you change any of the settings on the original carb? Is all the wiring around the carb still connected okay. fuel, compression and spark.Īre you running the original chinese spark plug? if so swop that out for the appropriate ngk alternative.ĭid you do anything else other than mess with the carb?Īre all the pipes firmly attached (be sure you've not left anything off) I dont have one of these so can only offer generic help.īasics are you need the three things. Any suggestions or solutions will be greatly appreciated. I've been working on this with good folks at forum for past month and thought I'd give you all a try. Is there something wrong with my engine? Or Electrical? Is bike a lost cause? The bike is brand new. When I try to keep starting it my battery will get drained so I have a dead battery now which I am recharging. I turned Pilot screw all way in then out 2 turns. When I try to start it I put choke on and give it throttle and the bike sputters like it wants to start but doesn't start. And it is getting good blue spark ok from spark plug as I tested it. The bike is getting fuel to the carb ok and getting air ok because air filter is very clean. About Press Copyright Contact us Creators Advertise Developers Terms Privacy Policy & Safety How YouTube works Test new features Press Copyright Contact us Creators. After I cleaned air filter and carb the bike wouldn't start so I purchased and installed new PZ30 Carburetor and bike still will not start. old XMoto 250cc which I purchsed from and I recently cleaned air filter and carb because it got very muddy. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |